Qix Bootleg 
-----------

single layer pcb, these pinouts were worked out directly from the pcb.
AC sections had been shorted so onboard regulators were not needed, 
all voltages derived from edge connector instead.

i could not find the audio output pins.

21.06.04
Andy Welburn
www.andys-arcade.com



             SOLDER                              PARTS
   ________________________________|___________________________________
             Gnd               | A | 1 |          Gnd
             Gnd               | B | 2 |          Gnd
             -5 Volt           | C | 3 |          -5 Volt
                               | D | 4 |          
             +5 Volt           | E | 5 |          +5volt
             P1 fastdraw       | F | 6 |          P1 slowdraw
             Switch 13         | H | 7 |          
             COIN              | J | 8 |          COIN
                               | K | 9 | 
             P2 START          | L | 10|          P1 START
             P1 RIGHT          | M | 11|          P1 LEFT
                               | N | 12|          P1 UP
                               | P | 13|          switch 04
             P1 DOWN           | R | 14|          
                               | S | 15|          
             Green             | T | 16|           Blue
             Sync              | U | 17|           Red
                               | V | 18|           Switch 03
                               | W | 19|          
             +12v              | X | 20|           +12v
             Gnd               | Y | 21|           Gnd
             Gnd               | Z | 22|           Gnd       
        
   --------------------------------------------------------------------