Pinouts for NAMCO Gee Bee (1978):
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Typed up by 
Andy Welburn - 13th April 2000
*******************
UPDATED 27/12/2009
*******************

I finally got round to wiring a real pcb up and found 
a few mistakes in the old document, so i've corrected
these now!

www.andys-arcade.com

This info was obtained from an original Gee Bee
service manual.

This manual was entirely in Japanese. Not being 
fluent in Kanji, i couldn't say precisely what each 
pin function is. However, they use numbers like 
everyone else, and can still draw accurate cabinet 
wiring diagrams, this means that the most important 
bits of wiring up a board can be accomplished.




44-pin edge connector
----------------------------------------------------
     +16v AC CT     | 1  | A  |    +16v AC CT
     +16v AC CT     | 2  | B  |    +16v AC CT
     +16v AC        | 3  | C  |    +16v AC
     +16v AC        | 4  | D  |    +16v AC
     N/C            | 5  | E  |    N/C 
     +8v            | 6  | F  |    +8v
     N/C            | 7  | H  |    N/C
     N/C            | 8  | J  |    
     CONTROL POT 2  | 9  | K  |    CONTROL POT 1
     N/C            | 10 | L  |    N/C
     FIRE BUTTON    | 11 | M  |    COIN 1?
     1P START       | 12 | N  |    2P START
     COIN 2?        | 13 | P  |    N/C
     CP SW GND      | 14 | R  |    VIDEO GND
     AUDIO          | 15 | S  |    VIDEO 
     2P START LAMP  | 16 | T  |    1P START LAMP
     COIN COUNTER?  | 17 | U  |    FIRE BUTTON LAMP
     N/C            | 18 | V  |    LOCKOUT COIL
     24v AC         | 19 | W  |    24v AC
     24v AC         | 20 | X  |    24v AC
     24v AC CT      | 21 | Y  |    24v AC CT
     AUDIO GND      | 22 | Z  |    COIN SW GND
     


All info supplied above is accurate to my knowledge, and i accept 
full responsibilty if your incompetance results in a blown 
board/monitor/house fuse/mind.

All enquiries about sueing me should be forwarded to the above email
address where i will invite you to kiss my big fat juicy grits.



enjoy! ;)