Taito - Crazy Balloon Pinouts
-----------------------------
by Andy Welburn
http://www.andysarcade.net
on a dark night 17/09/06

These were typed up from an original manual, and then verified by 
me wiring the sucker up right afterwards.


CLN0001 pcb (top board)

    SOLDER SIDE      PARTS SIDE
             ___________
         GND |  A | 1  | GND
         GND |  B | 2  | GND
        +12V |  C | 3  | +12V
    -SPEAKER |  D | 4  | +SPEAKER
         -5v |  E | 5  | -5v
         KEY |  F | 6  | KEY
   counter + |  H | 7  | coin lockout +
        +18v |  J | 8  | coin lockout -
   video GND |  K | 9  | video (composite b/w)
 video Green |  L | 10 | video Red
  video sync |  M | 11 | video Blue
  coin pulse |  N | 12 | name reset
  service sw |  P | 13 | tilt
       sw 2P |  R | 14 | sw 1P 
    2P Start |  S | 15 | 1P Start
       2P Up |  T | 16 | 1P Up
     2P Down |  U | 17 | 1P Down
    2P Right |  V | 18 | 1P Right
     2P Left |  W | 19 | 1P Left
      2P Fly |  X | 20 | 1P Fly
         +5v |  Y | 21 | +5v
         +5v |  Z | 22 | +5v
             ^^^^^^^^^^^

**** interestingly sw 1p, sw 2p, 1p fly, and 2p fly are not used ****



CLN0002 pcb (bottom board)

 This is like an old style connector, there is
no difference between top and bottom traces.
         ______
         |  1 | GND
         |  2 | GND
         |  3 | +12v
         |  4 | +5v
         |  5 | 
         |  6 | -5v
         |  7 | KEY
         |  8 |
         |  9 | RESET
         | 10 |
         | 11 |
         | 12 | 
         | 13 | -5v 
         | 14 | 
         | 15 | +5v
         | 16 | +12v
         | 17 | GND
         | 18 | GND
         ^^^^^^







enjoy!