Pinouts for Atari SPACE RACE (1973):
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Typed up by 
Andy Welburn - 13th November 2006
www.andysarcade.net

This info was obtained from a the Atari/Kurz-Kasch 
"Computer Games Operators Handbook", and was then
used to hook up a real pcb, so i know its right.

Do bear in mind that this game runs on a Black + White
monitor, so you'll have to work out some kind of hack
before you can convert it to JAMMA ;)


22-pin edge connector (double sided, single use)
----------------------------------------------------
 | 1  | GND
 | 2  | GND
 | 3  | 
 | 4  | AC
 | 5  |
 | 6  | AC
 | 7  |
 | 8  | +5v (for credit LED)
 | 9  | Left player UP
 | 10 | Right player UP
 | 11 | Video
 | 12 | Left Player DOWN
 | 13 | Right Player DOWN
 | 14 | Credit LED
 | 15 | Antenna
 | 16 | Start N.C
 | 17 | Start N.O
 | 18 | Coin N.O
 | 19 | Coin N.C
 | 20 | Audio
 | 21 | GND
 | 22 | AC Centre Tap


All info supplied above is accurate to my knowledge, and i accept 
full responsibilty if your incompetance results in a blown 
board/monitor/house fuse/mind.

All enquiries about suing me should be forwarded to the above 
address where i will invite you to kiss my big fat juicy grits.


enjoy! ;)