Qix Bootleg 
-----------
typed up by Andy Welburn on 21.06.04
http://www.andysarcade.net

This is a single layer pcb, these pinouts were worked out directly 
from the pcb. The AC sections had been shorted so onboard 
regulators were not needed, all voltages derived from edge 
connector instead.

note               : I could not find the audio output pins.
note #2 (03/11/06) : I have no idea where this pcb went, i lost it? :|



             SOLDER                              PARTS
   ________________________________|___________________________________
             Gnd               | A | 1 |          Gnd
             Gnd               | B | 2 |          Gnd
             -5 Volt           | C | 3 |          -5 Volt
                               | D | 4 |          
             +5 Volt           | E | 5 |          +5volt
             P1 fastdraw       | F | 6 |          P1 slowdraw
             Switch 13         | H | 7 |          
             COIN              | J | 8 |          COIN
                               | K | 9 | 
             P2 START          | L | 10|          P1 START
             P1 RIGHT          | M | 11|          P1 LEFT
                               | N | 12|          P1 UP
                               | P | 13|          switch 04
             P1 DOWN           | R | 14|          
                               | S | 15|          
             Green             | T | 16|           Blue
             Sync              | U | 17|           Red
                               | V | 18|           Switch 03
                               | W | 19|          
             +12v              | X | 20|           +12v
             Gnd               | Y | 21|           Gnd
             Gnd               | Z | 22|           Gnd       
   --------------------------------------------------------------------